Digital Graphic Equalizer Audio Digital Equalizador de audio Professional sound

Description

Digital Graphic Equalizer Audio Digital Equalizador de audio Professional sound
✅.Power supply:
220V /110V
✅.Sound transmission gain:
-1dB or 11dB
✅.Line input impedance:
15KΩ
✅.Line output impedance:
300Ω
✅.Frequency response:
20Hz-20kHz
✅.Signal to noise ratio:
82dB
✅.Power consumption:
30W
◆Standard 1U thin and light rack
◆Dual-channel synchronous control 31-band DSP processing equalizer
◆Each section with LED spectrum indication, real-time 31-band frequency point absolute accuracy 99%
◆With noise reduction function of cutting-edge noise gate
◆The input and output interface supports multiple types: TRS6.35/RCA Lotus/XLR XLR CANNON balanced interface
◆EQ bypass: bypass the graphic equalizer in the signal path With save and recall function, 10 modes can be saved and recalled.
1.SAVEbutton (press theSAVEbutton, turn the knobCONTROLorGAINto select any mode 1-10, after the screen displays the number 1-10, pressSAVEafter confirming the mode to save the mode successfully)
2.RECALLbutton (press the RECALL button, turn the knob Controller GAIN to select any mode 1-10, the screen will display the number 1-10, after confirming the mode, press RECALL to call the mode successfully)
3.EQ BYPASS pass-through button (press the EQ BYPASS button, the machine does not undergo any frequency band numerical adjustment, the screen displays "--" The current state is the pass-through function, then press to cancel the pass-through function)
4.TheLCEdisplay shows the volume of the signal passing through the machine "01-100", the saving and recalling mode "0-10" is attenuating "±18db", the value "-" is in the state
5.CONTROLsystem control knob (when the machine is stationary, turn the CONTROL knob to adjust the volume of the machine, press the CONTROL knob to start the frequency band parameter adjustment, turn the knob to the 20-20K frequency band, the blue light under the corresponding frequency band on the panel will flash, Rotate the GAIN knob to increase or decrease)
6.20db-20K: 3.1-segment spectrum display light, 20db-20K frequency band selection (when the signal is input, the 31-segment signal will change according to the strength of the corresponding frequency band signal, the green light indicates the normal state, the yellow light indicates the warning state, and the red light Indicates the peak state, the blue light static state represents normal, the blue light flashing represents the increase in frequency band parameters can be adjusted attenuation)
7.GAINparameter gain attenuation knob (when the machine is stationary, turn the knob to adjust the volume of the machine, press the GAIN knob to start frequency band parameter adjustment, turn the knob to the 20-20K frequency band, the blue light below the corresponding frequency band on the panel will flash ,It can be attenuated by turning the GAIN knob to increase, flashing for 8 seconds without operation, automatically exit this function)